Reliability Measurements of the Furniture Frames with Selected Joint Types

Basit Öğe Kaydı
dc.authorid0000-0003-0114-3030
dc.contributor.authorUysal, Mesut
dc.date.accessioned2026-02-08T15:15:48Z
dc.date.available2026-02-08T15:15:48Z
dc.date.issued2024
dc.departmentBursa Teknik Üniversitesi
dc.description.abstractThe reliability was evaluated for frame construction with mortise and tenon (MT), dowel, and non-glued and glued staple joints made of beech wood. The moment capacities of the T-shaped joints were determined under static vertical loads. The MT joint had an average moment capacity of 204 Nm, followed by dowel joints (154 Nm). In staple joints, joint strength increased after gluing. A three-seat sofa frame was defined and theoretically subjected to loads on arm rails, side rails, and back posts. Moment levels on the joint of the frame were obtained by using the stiffness method. To measure the reliability, these moment levels were assumed to be normally distributed with a coefficient of variation of 10%; accordingly, the normal distribution of the data sets was transformed into a normal standard distribution, and then, the reliability of each joint on the frame was obtained by using probabilistic approaches. MT joints were found to have the highest moment capacity and, correspondingly, the highest reliability (99.99%). Gluing the staple joints increased the strength, so their reliabilities were increased. In designing frame construction, the critical joints should be determined, and then, the joinery system with the higher reliability should be used.
dc.identifier.doi10.15376/biores.19.3.6120-6141
dc.identifier.endpage6141
dc.identifier.issn1930-2126
dc.identifier.issue3
dc.identifier.scopus2-s2.0-85200374684
dc.identifier.scopusqualityQ3
dc.identifier.startpage6120
dc.identifier.urihttps://doi.org/10.15376/biores.19.3.6120-6141
dc.identifier.urihttps://hdl.handle.net/20.500.12885/5974
dc.identifier.volume19
dc.identifier.wosWOS:001286209000042
dc.identifier.wosqualityQ2
dc.indekslendigikaynakWeb of Science
dc.indekslendigikaynakScopus
dc.language.isoen
dc.publisherNorth Carolina State Univ Dept Wood & Paper Sci
dc.relation.ispartofBioresources
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanı
dc.rightsinfo:eu-repo/semantics/openAccess
dc.snmzWOS_KA_20260207
dc.subjectReliability
dc.subjectProbabilistic approach
dc.subjectMortise and tenon joints
dc.subjectDowel joints
dc.subjectStaple joints
dc.subjectNormalizing
dc.subjectMultiple failure modes
dc.subjectParallel system
dc.titleReliability Measurements of the Furniture Frames with Selected Joint Types
dc.typeArticle

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu