EVALUATING DESIGN OF MORTISE AND TENON FURNITURE JOINTS UNDER BENDING LOADS BY LOWER TOLERANCE LIMITS

Basit Öğe Kaydı
dc.authorid0000-0002-9651-1811en_US
dc.contributor.authorUysal, Mesut
dc.contributor.authorHaviarova, Eva
dc.date.accessioned2022-08-05T13:28:36Z
dc.date.available2022-08-05T13:28:36Z
dc.date.issued2021en_US
dc.departmentBTÜ, Orman Fakültesi, Orman Endüstri Mühendisliği Bölümüen_US
dc.description.abstractThis study aimed to estimate the design value for mortise and tenon joints. In this respect, the design value for static load tests was determined using lower tolerance limit methods. A lower tolerance limit value at 0.99/0.99 confidence/proportional level was chosen as a design value (199.05 N.m) to secure higher joint reliability in a furniture frame. A side frame of a simple wooden chair was theoretically analyzed to obtain internal forces acting on joints, whereas the load of 1000 N was applied in the vertical direction on the top of the front leg. A full-frame chair with mortise and tenon joints was then designed using the calculated lower tolerance limit design value. This action ensured that joints would not be overstressed when a chair is under static load while not exceeding 2000 N. By applying this method, all chairs should survive static load up to 2000 N. While performing cyclic front-to-back load test, all tested chairs met the American Library Association requirements for light-duty service load, specified for household chairs. This study demonstrates that a joint failure could be prevented under expected loads specified by the standard if the joint design value is known.en_US
dc.identifier.doi10.22382/wfs-2021-13en_US
dc.identifier.endpage125en_US
dc.identifier.issn0735-6161
dc.identifier.issue2en_US
dc.identifier.scopusqualityQ2en_US
dc.identifier.startpage109en_US
dc.identifier.urihttps://hdl.handle.net/20.500.12885/2028
dc.identifier.volume53en_US
dc.identifier.wosqualityN/Aen_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.institutionauthorUysal, Mesut
dc.language.isoenen_US
dc.publisherSOC WOOD SCI TECHNOLen_US
dc.relation.ispartofWOOD AND FIBER SCIENCEen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectFurniture strength designen_US
dc.subjecttolerance analysisen_US
dc.subjectdesign valueen_US
dc.subjectmortise and tenon jointsen_US
dc.titleEVALUATING DESIGN OF MORTISE AND TENON FURNITURE JOINTS UNDER BENDING LOADS BY LOWER TOLERANCE LIMITSen_US
dc.typeArticleen_US

Dosyalar

Lisans paketi
Listeleniyor 1 - 1 / 1
Küçük Resim Yok
İsim:
license.txt
Boyut:
1.44 KB
Biçim:
Item-specific license agreed upon to submission
Açıklama:
İndir

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Orman Endüstri Mühendisliği Bölümü Yayın Koleksiyonu